Hyundai ix55 Bosch EDC16CP34 Original ECU File E4AEI4SV01 39120-3A000D0ENCA4EI02S

This listing is an original flash/calibration file for Hyundai ix55. It is not a full backup, not a processor clone, and not an immobilizer EEPROM.

Match hardware 39120-3A000D0ENCA4EI02S and software E4AEI4SV01 before you write. Verify exact HW/SW before programming.

Vehicle engine on this listing: 3.0 CRDI. Do not assume a neighbouring engine uses the same calibration.

What this file is

It is a stock calibration for professional workshops. A neighbouring software version can still fail a checksum or leave a no-start.

Related services

• Full backup (complete image for clone or recovery) is a separate product at €20 when that file exists — this listing is an original flash/calibration file — it is not a full backup. If it is not listed, use Request Full Backup.
• Corrupted ECU File Repair (digital file after a failed write, not physical ECU electronics): €50 — contact support with HW/SW and the tool you use.

Professional use only

These files are intended for professional tuners, ECU specialists and workshops. You must understand flashing, checksums, boot/bench recovery and the risk of a no-start. We do not sell this as a DIY kit for untrained use.

Digital product — no refund after payment

This is a digital file delivered after payment. Once it is paid we cannot refund, reverse or take back the download. Check hardware and software numbers on the controller sticker before you buy.

FAQ

Is this a full backup?

No. This is an original flash/calibration file only — not a full backup. A full backup is a separate product when that file exists (€20).

Who can use this file?

Professional tuners, ECU specialists and workshops. Confirm HW/SW before payment. This is a digital product and cannot be refunded once paid.

What if the write fails?

Corrupted ECU File Repair (digital recovery, not physical electronics) is €50. Contact support with the identifiers on this page and the tool you use.