Download the original ECU flash file for the Audi S6 4.0 TFSI running Bosch MED17.1.1. This listing is stock flash / calibration data only — not a full ECU backup, not a processor clone, and not an immobilizer EEPROM.

Match hardware 4G0906014 and software 4G0906014 before you write. A neighbouring software version on the same S6 can still fail the checksum or leave a no-start.

Use this OEM flash to restore factory calibration after a bad remap, to compare a modified dump, or to prepare a professional write. Hardware 4G0906014 with software 4G0906014 is a different package from other Audi original files on this site.

What this Audi S6 original file is

It is the stock map for professional tuners and ECU repair shops. If you need a complete ECU image for cloning or brick recovery, that is a full backup — sold separately on request for €20. ECU flash repair after a failed write is €50.

Full backups and ECU flash repairs

• Full ECU backup (complete image for clone or recovery): €20 on request — this original listing is a flash / calibration file only — it is not a full backup.
• ECU flash repair after a failed write or brick: €50 — contact support with HW/SW and the tool you use.

Professional use only

These files are intended for professional tuners, ECU specialists and workshops. You must understand flashing, checksums, boot/bench recovery and the risk of a no-start. We do not sell this as a DIY kit for untrained use.

Digital product — no refund after payment

This is a digital file delivered after payment. Once it is paid we cannot refund, reverse or take back the download. Check hardware and software numbers on the ECU sticker before you buy.

FAQ — Audi S6 original flash

Is this a full ECU backup?

No. This Audi S6 page is an original flash / calibration file only. A full backup is €20 on request.

Who can use this file?

Professional tuners, ECU specialists and workshops. Check HW/SW on the ECU before payment. This is a digital product and cannot be refunded once paid.

What if the write fails?

ECU flash repair / recovery is €50. Contact support with hardware 4G0906014, software 4G0906014, and the tool you use.